A wood crusher is a crushing type of mechanical equipment,

In the global landscape industry, power plants, paper mills, furniture factories, artificial plate industry, agriculture, orchards, and so on,

A number of industries have a wood crusher equipment figure.

The reason why wood crushers can be widely used in so many industries,

Mainly depends on the wide range of crushed raw materials, and the use of crushed materials is also very wide,

For example papermaking, power generation, cushion material, feed, fertilizer, organic mulch, sawdust board, particleboard, fiberboard,

MDF, Buddhist incense, mosquito coil incense, insulation materials, furniture, tables, chairs, edible fungi, etc.

These wood products can be crushed by a wood crusher, the production of materials to replace the production of logs,

And enterprises using this material can greatly reduce production costs, and play a good effect in killing many birds with one stone.

While many people may operate wood mills regularly,

But are you sure you’re doing it the right way?

To know a good operating method and good operating habits,

It not only helps to improve the output and crushing efficiency of wood mill equipment,

More importantly, it can also improve the service life of wood mills,

Reduce the probability of failure and so on,

Today let Xiaobing for you to say what skills there are in the operation of a wood crusher:

First of all, every time we turn on the machine, we have to carry out a comprehensive inspection of the wood grinder,

This is necessary because it not only prevents various failures due to component failure,

Minor problems can be nipped in the bud,

Many wood mill users ignore small problems,

Over time these small problems become big problems,

And then lead to the failure of the wood mill can not carry out normal production operations,

Make sure there is no problem then you can switch on the power,

But instead of going directly into production,

We can first listen to the internal wood mill has the same sound, and vibration, if there is to immediately stop the internal inspection of the wood mill,

Confirm that there is no problem before starting the production operation;

And then there are the techniques that we use to operate the wood shredder,

First of all, we should pay attention to the speed of feeding,

Too fast will lead to the production operation of the wood mill under load,

In turn, the temperature of the bearing and the motor will continue to rise,

And then it burns or it gets damaged,

Too slow, however, will lead to wood crushing operations in the idle running for a long time,

This seriously affects the output and crushing efficiency of the wood mill,

Therefore, we must maintain a uniform rate of feeding, which not only prevents the above two situations from happening,

At the same time, it also helps to improve the output and crushing efficiency of the wood mill,

Of course, we can also determine the speed of feeding according to the size of the raw material,

If the material is too large, the feeding speed can be slowed down appropriately.

The raw material with too small a volume can properly accelerate the feeding speed.