+86-189 9846 0024
When the wood pellet machine is pressing the wood pellets, sometimes it is not shaped, and the pressed particles are loose, so the particles cannot be pressed. Then the reason why the particles are not formed can be seen from the following three aspects:
The output of the wood pellet machine is too low or has no output: cause of the issue: 01. The first time the mold is used, the finish of the mold hole is poor; 02. The pressure roller or mold is aging and severely worn; 03. The moisture content of the material is too high or too low; the gap between the pressure roller and the mold is too large;
When the wood pellet machine is blocked, do not poke the machine cavity with a stick, stop the feeding first, stop the wood pellet machine after about ten minutes of operation, turn off the power to find out the reason:
When operating the wood pellet machine, after the raw materials are tempered, the suitable water content should be 15% to 16.5%. The specific judgment is that it is better to form a ball by hand and disperse it after letting go. The gap between the pressure roller and the ring die has a great influence on the granulation quality.
The wood pellet machine should be fixed on the ground and can be fixed with cement. The motor of the wood pellet machine should be installed on the base made of angle steel. Before starting the machine, it is necessary to test the machine before starting the machine: simply turn the main shaft to see if the bearing is running normally.
The quality of the wood pellet machine has an absolute guarantee, but there are also many users who have caused great damage to the machine due to lack of daily maintenance during use, so let me introduce several major failure causes of the wood pellet machine that are easy to ignore:
Navigation
Products
Contact Us
+86 19157405032