Email:[email protected] Wechat:19157405032 WhatsApp:+86 19157405032 Address:Yinhu Industrial Zone, Tianhe District, Guangzhou city
company news
Your current location: Home > company news > Daily Maintenance of the Wood Pellet Machine
Daily Maintenance of the Wood Pellet Machine

At present, Shuntec wood pellet machine equipment has spread to all parts of the country on a large scale. The pellet machine is easy to operate and flexible and is favored by customers and friends. However, no matter how good the machine is, there will be problems, so do a good job of daily maintenance. Very importantly, the following introduces the simple maintenance of wood pellet machine equipment:

1. If there is an impact sound when the rotating gear of the wood pellet machine is running, it should be stopped immediately for inspection and eliminated;

2. Pay attention to checking the wear degree of the wearable parts of the wood pellet machine, and replace the worn parts in time;

3. Pay attention to whether the work of each part of the wood pellet machine is normal;

4. The shaft of the wood pellet machine bears the full load of the machine, so good lubrication has a great relationship with the life of the bearing. Therefore, the lubricating oil injected must be clean and the seal must be good;

5. The hoop installed on the wood pellet machine is easy to loosen and must be checked frequently;

6. If the bearing oil temperature rises, stop the machine immediately and check the cause to eliminate it.

In the process of daily maintenance, mold is very important. Under normal production conditions, the mold maintenance pressure wheel bearing of the wood pellet machine must be cleaned once with gasoline or diesel oil for no more than 30 days, and at the same time injected with high-speed lubricating grease. During the work, it is necessary to ensure that the raw materials are free from stones and iron filings, so as not to damage the mold of the pellet machine. Before working in winter, the pellet machine should be preheated first, because the weather is colder and the stability is relatively low, so the preheating time should be longer, and the feeding work can be started after the mold temperature rises. In this way, the output can be improved, and the wear on the wood pellet machine is also small.