When the wood pellet machine is blocked, do not poke the machine cavity with a stick, stop the feeding first, stop the wood pellet machine after about ten minutes of operation, and turn off the power to find out the reason:

1. The operation of the wood pellet machine is not standardized:

Operators who do not understand the function of the wood pellet machine may feed faster when operating the wood pellet machine, increasing the load on the machine, and resulting in the blockage of the wood pellet machine.

2. The cutting tool of the wood pellet machine is not delicate enough, and it is easy to cause broken cutting and waste:

This situation is generally caused by the inconsistent center of gravity of the main shaft of the wood pellet machine and the center of gravity of the tool during the processing process. When the spindle is operating at high speed, if the spindle and the tool are not concentric, it will not only affect the yield of finished products but also affect the processing effect.

3. Fine wood chips will accumulate inside the motor or tuyere of the wood pellet machine:

After one week of operation, the wood pellet machine needs to be cleaned, and after one month of operation, it needs to be protected and maintained on a large scale.

4. Replace the hammer or screen of the wood pellet machine in time:

If the hammer and screen of the wood pellet machine are damaged and the new parts are not replaced in time, the crushed material has high hardness and the humidity exceeds a certain standard, which will cause mechanical blockage. In order to ensure the working efficiency of the wood shredder, the damaged parts should be replaced in time, and the humidity of the wood should not be higher than 14%.