1. Raw material moisture is too low or too high

If the water content is too high, there will not be too much powder, but the hardness of the particles is low, and the particles are easy to loosen. If the moisture content in the raw material is low, it is difficult to form too much powder. At this time, the moisture content of the raw material of the wood pellet machine should be properly controlled.

2. The wood pellet machine has a high degree of wear and tear

Due to the excessive wear of the wood pellet machine mold, the mesh is very smooth, resulting in severe expansion. Therefore, compared with the normal value, the pressure of the pellets is reduced, which seriously affects the formation speed of the pellets and causes the pellets to be too large. At this point, the mold should be replaced.

3. Wood pellet machine aging machine

The aging of the wood pellet machine makes the capacity insufficient, and the motor cannot supply the normal speed, which leads to the lack of pressure and cannot be pressed into pellets. At this time, the motor of the wood pellet machine should be replaced.

The operating parameters of the wood pellet machine directly affect the movement characteristics of the material, which in turn has an important impact on the production efficiency of the equipment. Therefore, the operating parameters of the equipment should be reasonable in production. In order to improve the productivity of the equipment, the design of the pressure roller and mold of the wood pellet machine is usually improved, and based on the improved pressure roller and mold, better operating parameters are provided to match the mold and materials so that the production efficiency of the equipment is higher.