+86-189 9846 0024
Wood pellet machine mold cracks increase the cost of machine production. In use, how to prevent wood pellet machine mold cracks? As a granulator manufacturer, you should control the material, hardness and heat treatment uniformity of the mold from the source, and set the appropriate compression ratio according to the user's material, and inform the user of the precautions. Only by starting from the following points can the cracking of the wood pellet machine mold be well reduced or reduced.
The basic principle of the sawdust pellet machine is to make the powder into flakes, then crush whole pellets. Therefore, the yield rate is directly related to raw materials, and the yield rate of raw materials with good compressibility is higher.
After the operation of the sawdust pellet machine is finished every day, grind it with oil for a period of time to ensure that the oil remains in the die hole, which is of great benefit to the work of the next day and is also conducive to the long-term use of the die.
The compression ratio of the sawdust pellet machine mold is incorrect. The compression ratio and moisture are equally important factors. One is controlled in the raw material, and the other is controlled in the mold. Two ratios are essential. In particular, it should be noted that, for example, when the sawdust particles are pressed, it is suddenly found that the sawdust is insufficient, and adding other miscellaneous woods will also seriously affect the production.
The long-term use of the sawdust pellet machine will cause the axial pressure to wear and the parts to fail, which will cause the axial pressure to slip and fail to work normally.
When the sawdust pellet machine is blocked, do not poke the machine cavity with a stick, stop the feeding first, stop after about ten minutes of operation, and turn off the power to find out the reason.
Navigation
Products
Contact Us
+86 19157405032